The szivattyu in Hungary have the knack to run out and stop working, usually when they are turned off for a long period of time. If you want to start the Grundfos szivattyú in Hungary working again, you will have to prime it. This simply means that you have to get the water to flow and force the pump to operate. You can prime your pump by following the steps mentioned below.

Get Started On Pump Priming

You have to start by gearing up the pump system in Hungary. You have to first switch the pump off. This is a step of caution more than a real step. Then you have to start locating for the plumbing fixture. This will give you access to prime the pump in Hungary. If you are working with a pool pump, the fixture will be the strainer basket. If it is other szivattyu, you have to look closely around the water tank for the fixture. Then you have to prepare a hose and proceed to connect it a water source. You need to do this because it will flush and clean the hose from build-ups and will give you clean water. Make sure that your hose dos not have lead, and then you will have to filter the water. Then you must flush the hose so that it removes build-ups. You have to make sure that water runs for at least a few minutes especially hoses that have not been used for some time. If your pump has any relief valves, you have to open it to prevent pressure from building.

How To Flush System

Then you must start to insert the hose to the fixture of the Grundfos pump system in Hungary. If it is a pool pump you can simply connect it to the strainer basket. For other szivattyu you have to connect to the water tanks. Then you must turn the water on to the hose. If you hear air flowing, you don’t have to worry. This is normal and happens at the beginning before water starts flowing. Then you have to let the water fill the tank. A water pressure gauge is helpful as it will show the level. Once the water starts coming off the end of the valve you have to shut it off.

Finish The Job Successfully

Finally you have to power the pump again and turn the system on. You have to let the pump run for say a minute. You have to observe if it runs. This is because if the pressure was not at the point or above the point of szivattyu cut out pressure it will not run. If the pump turned off on its own then you have done the job right. If not you will have to prime the szivattyu in Hungary again.